Salads

 

Monica's Toss Salad


Ingredients:

  • 1 head lettuce
  • 1 can mandarin oranges (drained)
  • 1 bunch green onions (chopped)
  • 1 package Almonds

Directions:

  1. Toasted almonds:  2 T. sugar + 2 t. water + 1 pkg almonds in microwave for 2-3 min, stir occasionally
  2. Toss with dressing just before serving

Sweet & Sour Dressing:

  1. 1/3 C. oil
  2. 3 T. sugar 
  3. 3 T. white vinegar
  4. 3/4 t. salt
  5. Dash pepper
  6. Mix together in shaker, pour over lettuce and toss


American Oriental Salad


Ingredients:

  • 1 pkg Oriental flavored Ramen noodles
  • 1 small cabbage head - chopped
  • 1/2 C. toasted almonds (baked @ 250 for 10 min)
  • 1 can water chestnuts - sliced & drained
  • 1 small can mandarin oranges - drained
  • 1 bunch green onions - chopped

Directions:

  1. Crumble noodles in cabbage
  2. Pour dressing over cabbage mixture
  3. Chill overnight to allow flavors to develop

Dressing:

  1. 1 C. oil
  2. 1/3 C. vinegar (or raspberry vinegar)
  3. 1/3 C. sugar
  4. Flavor package from noodles


Popular posts from this blog

Tascam DR-05X Recording Setup

Image
  Below is the recording setup we have started with.  The Tascam DR-05X handheld recorder set to 16 bit, 44.1k WAV format (typical CD quality).  The line-out going from the Teac TN-300 turntable is going straight into the Tascam and the blue output from the Tascam is going back to the speaker so we can hear what we are recording.  Manual recording level is set to 5 to avoid saturation and the external battery bank allows for many hours of rechargeable recording time.  We already had all of these components so we started here and with a good quality LP the quality of this recording setup is very good.  Post processing we are using Audacity to balance the channels and normalize the output and if necessary use WaveCorrector to remove pops and cracks.  Teac TN-300, Tascam DR-05X, Battery Bank Christmas Day, Various Artists LP   
Read more

Carver TFM-6C Recapping

Image
  Recapping: With the recapping kit for the Carver TFM-6C amp, we focussed on replacing the large 6800 uF capacitors.  Although holding acceptable values, we saw corrosion underneath so it was good time to remove them before they could leak and cause damage.   Idle Current Adjustment: After replacing the capacitors, we adjusted the idle current for each channel.  We initially measured it to be nearly 2x the specified value for this amp.  Each channel was initially reading 9 mV across the reference resistors but we set back to the desired factory setting of 5 mV using the adjustable onboard potentiometers.  It could be our imagination but the unit seems to sound a little clearer at the low end and maybe even less distortion at the high end.  But even if sound quality improvement is subtle this circa 1990s Carver amp is future proofed from major capacitor leaking for years to come. Below are some before and after photos. Old 6800 uF capacitors (bottom si...
Read more